#!/bin/sh -e rc.local This script is executed at the end of each multiuser runlevel. #dtoverlay=lirc-rpi Additional overlays and parameters are documented /boot/overlays/README Enable audio (loads $ ls /dev/fb* #dtoverlay=lirc-rpi Additional overlays and parameters are documented /boot/overlays/README Enable audio (loads snd_bcm2835) #arm_freq=800 Uncomment some or all of these to enable the optional hardware interfacesĭtparam=spi=on Uncomment this to enable the lirc-rpi module #config_hdmi_boost=4 uncomment for composite PAL #hdmi_drive=2 uncomment to increase signal to HDMI, if you have interference, blanking, or no display This can make audio work in DMT (computer monitor) modes #hdmi_mode=1 uncomment to force a HDMI mode rather than DVI. #hdmi_force_hotplug=1 uncomment to force a specific HDMI mode (this will force VGA) #framebuffer_height=720 uncomment if hdmi display is not detected and composite is being output By default it will be display's size minus overscan. #overscan_bottom=16 uncomment to force a console size. Use positive numbers if console goes off screen, and negative if there is too much border #hdmi_safe=1 uncomment this if your display has a black border of unused pixels visible and your display can output without overscanĭisable_overscan=1 uncomment the following to adjust overscan. See link above for details uncomment if you get no picture on HDMI for a default "safe" mode Any ideas? For more options and information see Some settings may impact device functionality. Could that have done it? I tried to redo all the steps but since I already have everything installed and have already edited the config files as directed, I can't figure out what else to do.
For some reason though, retropie has just suddenly stopped outputting to the screen - I haven't updated anything or changed anything, I did scrape some games.
Makefile:76: recipe for target 'all' failedĪny ideas what is going Thanks for your post, it was simple and plain worked. Make: *** Error 1ĬMakeFiles/Makefile2:60: recipe for target 'CMakeFiles/fbcp.dir/all' failed home/osmc/rpi-fbcp/main.c:8:22: fatal error: bcm_host.h: No such file or directoryĬMakeFiles/fbcp.dir/build.make:54: recipe for target 'CMakeFiles/fbcp.dir/main.c.o' failed Building C object CMakeFiles/fbcp.dir/main.c.o All works up until I run the "make" command and then I got a whole load of errors popup.